Supra Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
261 Posts
I worked with Suprapimp to fix his. we pulled the front end off the car. then got longer bolts from Home depot. (the 2 that hold it in from the top. I forgot the size of them.

Then u put the spacers between the IC and the cars frame and put the new bolt through. The spacers are so it doesnt rattle loose and you can tighten it down. Then bolt up the bottom hole of the IC (you may have to drill a new hole in the little tab at the bottom. You can slide the IC up and down a little bit. The pipes will rotate if you loosen up the connecting clamps. Also there might be a plastic grommet in the side of the engine bay where the pipe goes from the turbo. We just ripped that out to give you more movement for the pipes.

We shoulda taken pics.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top