Supra Forums banner
1 - 20 of 22 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter · #1 · (Edited)
OK Went back to the dyno yesterday to finish up a good customer/friends car. Last time on the dyno we ran out of fuel at 24psi with a single bosch 044. He added a second bosch. Everything turned out good this time around except for boost. The gate needs a little more adjustment. I couldn't get more than 27-27.5psi

Anyway here is the car and list
SC300
Stock usdm 2j motor
stock head just 264 cams
Old school billet 71mm- 27-27.5psi
rebuilt BL auto tranny
pte 1200cc
AEM V2
2 bosch 044
Tuned by charlie @M&S performance

I think thats it. This was at 27-27.5psi. The wastegate will be adjusted over the weekend and back to the dyno early next week.

 

·
Banned
Joined
·
2,386 Posts
any works on the bottom end or this is just a basically stock motor with 264 cams? if so this is great numbers geez...seems like every car that M AND S touches are making great power
 

·
Registered
Joined
·
373 Posts
Nice!
 

·
Registered
Joined
·
41 Posts
Discussion Starter · #5 ·
any works on the bottom end or this is just a basically stock motor with 264 cams? if so this is great numbers geez...seems like every car that M AND S touches are making great power
stock rods/pistons. It does have headstuds and the 264 cams. Nothing else is touched in it. No need to go crazy on his daily ;)
 

·
Banned
Joined
·
2,386 Posts
nice..its all about the tuning
 

·
Registered
Joined
·
41 Posts
Discussion Starter · #10 ·

·
Registered
Joined
·
41 Posts
Discussion Starter · #17 ·
hmmm this is making me reconsider where to get tuned do you guys have a website up?
Website is not up yet. Feel free to contact me or the owner of M&S on here. His SN on here is mikey2jz or send me a PM
 

·
Registered
Joined
·
41 Posts
Discussion Starter · #19 ·
M&S keeps providing some amazing cars and amazing numbers everytime. Can anyone guess who will be the ones helping me finish up my swap and the tune??????
Thank you for the kind words. We will see you soon:bigthumb:
 

·
Registered
Joined
·
58 Posts
Your PM is full. I have a 90 turbo that is burning oil , either from the turbo (center section is wet) or rings. Compression numbers are 110 (cyl1) to 125, I know low. No leak down done yet, maybe you guys can do it. Where are you guys located in queens and what is the shop phone number?
 
1 - 20 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top