MK3 parts FS or trade | Supra Forums

1 - 1 of 1 Posts

P

phaux

·

Guest

Joined Jan 1, 1970

·

0 Posts

Discussion Starter • #1 • Jan 20, 2002

Hello I have a few MK3 parts for sale or will trade for. All parts come from 1990 turbo with 101,000 miles on it and there all working.

SALE:
springs
air filter & box
wires(Magnecor I think)
exhaust
gas tank
BOV
power steering pump and resevoir
charcoal canister
DP and cat
back seats & seat belts

TRADE FOR:
EGT gauge
Boost gauge
MBC
ARP studs
MHG
aftermarket Fuel pump

Leave me an offer here or send email.

Thanks
[email protected]

1 - 1 of 1 Posts

Recommended Reading

Waste-gate stuck open?

Naturally Aspirated

I'm pretty sure this is a no brainier, but I had my car running up in the air on a lift after doing some repairs and inspecting. I noticed that the dump tube off of my waste-gate is puffing. Am I right to assume that the waste gate should not let anything past until it's spring pressure is...
- 23
- 323
- TrueGS300 · updated 13 h ago
Fuel pressure

Naturally Aspirated

I just got my return fuel system finished up and am having an issue with setting fuel pressure. I ran a Walbro 525 pump with an 8an feed and 6 an return. FuelLab regulator on the return, with a Radium Engineering gauge. All parts high quality. I can't get the gauge to read past 20psi. The car...
- 10
- 202
- TrueGS300 · updated 1 d ago
IS300 Coil Pack brackets for NA Supra?

Naturally Aspirated

Hi supraforum'ers, Does anyone know where I can buy some simple brackets that secure the IS300 coil packs in our non-vvti 2JZ-GE engines? I performed this coil pack conversion from a distributor cap and am planning a road trip, so I prefer them to be bolted down in a secure manner. :)
- 5
- 305
- W
  WarIsHate · updated 5 d ago
NA-T high increasing idle after IS300 coil pack conversion AEM v1

Naturally Aspirated

Hi Supraforum'ers, Has anyone experienced a high idle 2500 rpm + (that keeps increasing) after you converted from distributor to the IS300 coil packs with AEM EMS v1 (or similar engine management system)? I set the base ignition timing with AEMPower's wizard, and made sure the throttle body...
- 7
- 354
- W
  WarIsHate · updated 7 d ago
TPS calibration

Naturally Aspirated

Okay, so I have read the tsrm for the calibration method and was wondering how exactly to apply that to an aftermarket ffim with an RMR 90mm throttle body. Am I even using the right TPS sensor? I have the factory 2jzge (cali spec) TPS sensor on the car. The issue I'm having is uncontrollable...
- 14
- 798
- M
  merlin33bc · updated 9 d ago