Supra Forums banner

1 - 15 of 15 Posts

·
No One Ever Listens To Me
Joined
·
5,467 Posts
looks good...those welds are GORGEOUS... good job!
 

·
Republican
Joined
·
8,421 Posts
Good welds... what size tungsten did you use? Those are some tiny welds.
 

·
Premium Member
Joined
·
5,375 Posts
Discussion Starter #4
Ckanderson said:
Good welds... what size tungsten did you use? Those are some tiny welds.
Frankly I dont know, my welder made it. He's a professional welder. :)

Elbow is made of 3.5" and after that its reduced to 3".
 

·
Republican
Joined
·
8,421 Posts
oh... well he is good. :bigthumb: I wish I had made mine stainless now :( too expensive
 

·
Republican
Joined
·
8,421 Posts
So.. how does it sound? what kind of muffler is that in the middle?
 

·
Premium Member
Joined
·
5,375 Posts
Discussion Starter #8 (Edited)
SlimFastSupra said:
wow

kills the NUR spec

(if it was polished)
We'll actually I've been thinking of polishing the rear section of the exhaust that you can see behind the car to get that bling look :)

Ckanderson said:
So.. how does it sound? what kind of muffler is that in the middle?
Sound is sweet. Not too loud but nice tone @ WOT. I have the stock middle cat in there now to get through the emission test, after that I'll put a test-pipe to replace it. I'll get a sound clip after I've gotten my car back from the bodyshop and emission test :)

Not sure about the middle silencer, I can ask my friend if you like :)
 

·
Destroyer of Turbos
Joined
·
4,461 Posts
really nice welds man.... post up some clips of how it sounds when you get a chance. how low does it hang at the lowest point?
 

·
Stock Boost SUX
Joined
·
1,660 Posts
Looks damn good. Any scraping issues? Mine seems to be bottoming out on everything, I think my piping is too straight.
 

·
Premium Member
Joined
·
5,375 Posts
Discussion Starter #13
MASHedDough said:
Looks damn good. Any scraping issues? Mine seems to be bottoming out on everything, I think my piping is too straight.
No scraping issues yet, its pretty well made as you can see on the pics, my welder put a lot of time on it. Didnt come that cheap either. dp + exhaust was around 600USD. We'll see if it scrapes after I lower my car an inch more or so, but I doubt it :)

Thanks for all the positive comments guys, I'll make sure I tell my welder :)
 

·
Registered
Joined
·
501 Posts
That is pro fool, whats the note on the exhaust like?
 
1 - 15 of 15 Posts
Top