Supra Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
199 Posts
Discussion Starter · #1 ·
Hi,
Basically i have done and NA - TT (jap spec) engine swap and running the 5 spd tranny from the NA supra. The TT engine has come out of a Toyota Aristo as i got it from Malaysia. However i am using the J-Spec TT's wiring loom in the Aristo's engine (2JZGTE) and there are 6 connector pins in the Idle control sensor on the engine, but there are only 4 wires in the wiring loom that is supposed to connect to this sensor. anyone know what could be done???
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top