Supra Forums banner
1 - 2 of 2 Posts

· Just some guy
Joined
·
2,852 Posts
What exactly is interfering? Make sure the receptacle is in neutral and that the two pins on the housing make it into the notches on the shifter ball. Oh, and make sure you dont have the shifter turned backwards, cause it only goes in one way because of it's shape (i know its a no brainer but some people....)
 

· Just some guy
Joined
·
2,852 Posts
Theres the small ball on the very end with the bushing on it. Then theres the big ball where the shifter pivots. That big ball has a notch cut out on either side. The housing that the big ball goes into (the part on top of the tranny, held onto it with 6 bolts) has two pins, on on each side, which slide onto the pivot ball. Thats what holds the shifter in place.

Christian
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top