Joined
·
296 Posts
My cluth is about to go bye bye. Do you guys have any recommendations on one over the other. I am considering to add NOS (150 hp) soon.
Any recommendation is appreciate.
Any recommendation is appreciate.
Need help - NA 5 speed clutch
1 - 3 of 3 Posts
Joined
·
447 Posts
I just ordered a Stage III clutch from clutchmasters on Dave H's recommendation. $540. You can get the stage 1, which is organic and probably just a little better than stock, for $350 or so.
www.clutchmasters.com
www.clutchmasters.com
Joined
·
1,476 Posts
:nono: Go for a stage 3 or at least a 2 with that much "boost":smoker: Check the chart.
You should be smoking, not your clutch
You should be smoking, not your clutch
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Best EGT sensor (rtd type) location for NA-T?
Naturally AspiratedHi guys (and gals), Where have you folks installed your single egt sensor and how well did it work? I have a 2JZ-GE na-t car (non-vvti) and am curious where is the best place to weld in my AEM egt sensor (rtd type) bung. [easy access vs accurate readings... closer to an exhaust valve is more...- 2
- 49
-
2JZ-GE NA Running 14:1+ Compression
Naturally AspiratedWe are building SC300 with a 2JZ-GE NA for a Bonneville Land Speed record attempt. We're working through all the engine mods including a lot of head work. Based on the regulations we will need to run VP Racing Fuel C14. Possibly C14+ but it's unclear if that will pass tech. Does anyone have...- 9
- 357
-
IP Hexa Pac Ignition coils
Naturally AspiratedSo I am considering doing the COP conversion and not messing with the dizzy at all during an NA-T install. I just so happened to stumble upon these and couldn't find any info or anyone that had used them in the search...- 1
- 96
-
TougeSC3 · updated
-
IS300 Coil Pack brackets for NA Supra?
Naturally AspiratedHi supraforum'ers, Does anyone know where I can buy some simple brackets that secure the IS300 coil packs in our non-vvti 2JZ-GE engines? I performed this coil pack conversion from a distributor cap and am planning a road trip, so I prefer them to be bolted down in a secure manner. :)- 3
- 177
-
Fluidampr Crank Pulley = -2 degrees mark?
Naturally AspiratedHi guys (and gals?), I’m in the process of upgrading my timing belt and crank pulley. When I aligned the bolt hole notches and overlaid my new Flyuidampr crank pully over the oem 2JZ-GE (non-vvti) one, the Fluidampr’s timing mark was at -2 degrees inline with the oem crank pulley’s white...- 4
- 158
Join now to ask and comment!