Supra Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
142 Posts
Discussion Starter · #1 ·
Has anyone successfully done it?

seems like it would be a tight situation to o ring it.

dont have a spare block to take down and see if they can o ring it.



sidenote:
if the cylinders were oringed would you use viton rubber orings for coolant and oil passsageways or use a copper or home made gasket?
 

· Registered
Joined
·
142 Posts
Discussion Starter · #4 ·
are you talking about a custom machine plate for all 6 cylinders?

i was talking about usging a seperate steel ring for each cylinder


machine shops in your area are expensive 600$ ouch


the only concern i have is the fact of room inbetween the cylinders..

might have to use a plate

Bill
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top