Supra Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
947 Posts
You could get away with just grooving the block too, rather than a full o-ring job. Should keep the gasket in place in the face of shearing forces too. Heck, might let the composites stand up better too, saving the costs for MHG's in those cases where the boost pressures are not getting out of hand.

Bob
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top