Supra Forums banner

On the coolant topic. . . .

704 Views 6 Replies 4 Participants Last post by  ocd
I recently replaced my coolant. It was approx 50/50 with water wetter. Strange thing is I couldn't get as much in as I took out. Is this normal? I believe I put in about a pint/quart less. Do I have to "burp" the air out? How?

Thank you.:)
1 - 7 of 7 Posts
did u also have your engine running too??? when puttin in fluid your supposed to leave your engine on, that way theres already some cooloant goin thru in the engine and in the radiator.
I was running the engine when I refilled the radiator, but still wasn't able to get as much coolant in as I took out.
That just happens sometimes. Just top off the radiator and check the fluid level in the overflow for the next few days. The system will "burp" itself if it needs to.

Chris L.
93.5 TT
superchrls said:
That just happens sometimes. Just top off the radiator and check the fluid level in the overflow for the next few days. The system will "burp" itself if it needs to.

Chris L.
93.5 TT
By far the best way is to top off the motor as well as the radiator. See the two heater hoses going over the #6 cylinder? One of them is easily removable from the vertical pipe just above the turbos.... remove... put a funnel in it... and fill it with your coolant/water mixture, then put the hose back on.....

Thank you drive through...

Andi
That's right. Thanks Andi. I never drain the engine though. I'm too lazy and I change the coolant pretty often.

For some reason I never have to add more water but I still check the overflow cuz I'm paranoid. I guess I'm just lucky? :)

Chris L.
93.5 TT
I'll try that. thanx andi
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top