Supra Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
530 Posts
Discussion Starter · #1 ·
I need a pic of the Center Support Bearing, aka Carrier Bearing, installed on a MK III Supra.

Also, anyone know of any changes between an '87 Supra 5 spd N/A and an '89 Supra Automagic N/A as far as the driveshaft goes? The local boneyard has an '89 Auto N/A that they say I can get the driveshaft out of if I want...
 

· Registered
Joined
·
530 Posts
Discussion Starter · #5 ·
The rear flange of the forward driveshaft.... mine doesn't seem to be pushed out as far as yours. I'm betting there is a spacer or 2, that are missing...

Anyone know what sizes/locations total there should be, spacer wise?

Also, length of the driveshaft, anyone?
 

· Registered
Joined
·
530 Posts
Discussion Starter · #7 ·
Need the length of the front driveshaft for the w58. This one is measuring 20.5", from the side of the yoke end (where the U Joint goes) to the end of the splined shaft for the rear flange to bolt to the rear driveshaft.

Also noticed 3 wires hanging out... red/yellow/black, at the end of the transmission... Starting to think this was a 5spd swap....
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top