Supra Forums banner

1 - 5 of 5 Posts

·
King Ding-a-ling!
Joined
·
3,195 Posts
Discussion Starter #1 (Edited)
I have a polished intake manifold that has been aesthetically modified (to look better on the exterior). Notice on the top outer driver side that there is no goofy line sticking out. That edge has been rounded off like an aftermarket manifold.
SOLD!






Fuel door / trunk release levers and cable $35.00 shipped to your door



Stock exhaust manifold $40.00 shipped to your door



Stock exhaust switching valve and actuator $50.00 shipped to your door




Brandon
 

·
King Ding-a-ling!
Joined
·
3,195 Posts
Discussion Starter #4 (Edited)
Intake still avalible.

Paypal address:
[email protected]

As per all of the PMs that I have received about how this maniflod was modded:
Here is a pic of a normally polished manifold. notice the extruded line that I circled in red. This line has been cut off and the edge has been ground to a nice smoothe curve.



Brandon
 
1 - 5 of 5 Posts
Top