Supra Forums banner
1 - 7 of 7 Posts

· Professional OT Bum
Joined
·
1,600 Posts
Discussion Starter · #1 ·
My friend has been working on his car, due to a bhg!, everything has been put back together and now it wont start doesnt even turn over or make a sound from the starter.

I found some wires and shit undone and he doesnt know if they belong to anything with the starter so if you know what these wires do or what we could look at to troubleshoot this problem drop a line...





 

· Professional OT Bum
Joined
·
1,600 Posts
Discussion Starter · #7 ·
just grounded it out on the bottom intake plenum like stated the bolt we had left over went in perfect so we know its now correct, but the car still has the same problem , when attempting to start it will have a minor click sound that comes from the coils *sorta but No sound from the started at all. we have looked at most visible fuses and all are ok, but the solid metal ones we cannont tell.
does anyone know which fuse is for the starter?
or does anyone know what else could be looked for , with this issue

thanks alot.
nick
 

· Professional OT Bum
Joined
·
1,600 Posts
Discussion Starter · #10 ·
Ok , so we went back cleaned every thing still wouldnt turn the starter. So I decided to jump start the starter manually with a positive wire going from the starter positive side to a positive battery terminal while the key was being turned forward.

So the mother fucker turns over no problems fuel pressures on the rise oil pressure then it becomes apparent that the bitch isnt going to fire it just sputters, when I let off the starter. and nothing happens..

Now Im guessing its a timming issue so he calls the guy he got the head from and he said the cams where never aligned up tdc or to there correct spec so now, were going to need what parts and stuff to line them up?

I figured cam puller and timming light wouldnt that be everything needed to get the cams dialed into sync with the cam gears, and then line the crank notch tdc and in line with the cam notches then put the cam belt on correctly and it should fire in proper order and run.

Or its going to be towed to a place locally and get fixed cause we dont know what the issue is with the damm starter everything was fine before now this shit and the cams out of sync, had a cracked cam journal bolt and problems one after another :sadwavey:
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top