Joined
·
226 Posts
I was wondering if the radiator fan on my SC300 (GE) is the same as the one on the GTE engine? Thanks.
Radiator fan same for GE and GTE?
Join the discussion
Recommended Reading
-
Any successful 6R80 swaps into an MKIV yet?
MKIV (1993-1998)I know there was some talk at one point, but has there been any successful 6R80 swaps into a MKIV yet? We know the stock 6R80 can handle plenty of power, the mustang guys see plenty of 10 sec passes and even some into the 9s. We know the tunnel will need a massage, we know there's the...- 55
- 7K
-
Casey James · updated
-
Oil pump installed. Now my motor shakes
MKIV (1993-1998)Hey everyone, first post here. 2 weeks ago, I noticed there was a small oil leak from the RTV seal around my oil pump so I dropped the pan, pan girdle, reapplied RTV and put it all back together. Upon first startup, i noticed my oil pressure was really high at 125. I gave it a little throttle...- 6
- 152
-
turbo_tacoma · updated
-
Breakup with GE non-vtti ignition
MKIV (1993-1998)Hey guys, I’m at a loss. Made at 423whp on a dynojet - roughly 12psi in a S366, and I can’t go half a pound higher without the ignition breaking up. ems v2 Hks DLI Bkr7e’s gapped to .020 New cap, rotor, NGK wires I have a replacement coil coming in, but I doubt that’s the issue. I see people...- 5
- 165
-
Help identifying modded ecu (G-Force?)
MKIV (1993-1998)So my aristo ecu took a crap on me and I bought a JDM mk4 supra 6sp ecu. To my knowledge the JDM supra is map based with 440cc's so I technically should be able to run the ecu. The seller that I received the ecu from stated it's a G-Force ecu. From other G-Force ecu's that I have seen on the...- 11
- 5K
-
ATLspeed · updated
-
Exhaust Manifold Bolts with no washer?
MKIV (1993-1998)Hi Supraforums family, Is it okay to use exhaust manifold bolts without a washer or lock washer? Or, will they eventually back out or cause problems when the meta expands. I don’t have studs for all the exhaust manifold holes, so I just want this to work, but be safe too.- 2
- 124
Join now to ask and comment!