Supra Forums banner

RC Engineering 440 cc injectors

Jump to Latest Follow

1 - 9 of 9 Posts
S

·
Not so slow anymore
Joined
·
138 Posts
Discussion Starter • #1 •
i would have posted this in the parts for sale but i thought it might get better response in here.
I have a set of 6 RC engineering 440cc High Impedence injectors that i am not going to use.
Would there be anyone interested in these?

later
 
Verge

·
pirates like cookies
Joined
·
702 Posts
#9 •
2001... craptastic
 
Save Share
Reply
1 - 9 of 9 Posts
Recommended Reading
Read More

  1. which shroud?

    Naturally Aspirated
    Ok 'm performing m swap over the next two weekends and wanted to make sure I have everything that i am going to need. My question is which fan shroud do i need? I have read some things saying to get the TT upper shroud, but the little helper fan or fans won't work because there is no plug for...

  2. Fuel pressure

    Naturally Aspirated
    I just got my return fuel system finished up and am having an issue with setting fuel pressure. I ran a Walbro 525 pump with an 8an feed and 6 an return. FuelLab regulator on the return, with a Radium Engineering gauge. All parts high quality. I can't get the gauge to read past 20psi. The car...

  3. NA-T injector and resistor pack

    Naturally Aspirated
    I am running a full aristo swap in my is300. I have been using my stock IS ECU and piggybacked for adjustments. I stumbled across apost that says that I will fry my ecu if I 'm using low impedence injectors. I know that they are 440cc's from an aristo. I also know that my N/A ECU thinks its...

  5. 2JZ-GE TB port Check Valve flow direction?

    Naturally Aspirated
    Hi guys (and gals), Is my understanding correct that the check valve that connects the charcoal canister to that port on the throttle body should only flow into the throttle body and NOT back towards charcoal canister?

  6. 2JZ-GE Charcoal Canister testing + cleaning?

    Naturally Aspirated
    Greetings Supraforums Team, I tried to test my 2JZ-GE charcoal canoster per service manual instructions, but the 43psi “cleaning” method does not work. It just locks up and does not allow air flow out the bottom port. Lower pressures work fine ~20psi and less. Do I have this setup...
Read More
About this Discussion
8 Replies
7 Participants
Last post:
Verge
Supra Forums
Supra Forums is the largest online Toyota Supra MKI, MKII, MKIII, MKIV and MKV owner's club community. Discuss DIY, modifications, and upgrades.
Full Forum Listing
Explore Our Forums
MKIII (1986.5-1992) MKIV (1993-1998) Other Cars For Sale/Wanted - Parts, etc. Members Rides
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Working From Home Forum - New!
Working From Home Forum - New!
25+ members
Join
Top