re:NA strut bar | Supra Forums

1 - 3 of 3 Posts

R

radayton

·

Guest

Joined Jan 1, 1970

·

0 Posts

Discussion Starter • #1 • Feb 5, 2002

re:NA strut bar

need help- do you have a phone number and/or web site for Top Secret or MVP? none of my suppliers do. thankyou much.

93MSB

·

ส็็็็็็&

Joined Feb 12, 2001

·

919 Posts

#2 • Feb 5, 2002

click the MVP banner at the top of the page

S

StaticX313

·

Guest

Joined Jan 1, 1970

·

0 Posts

Discussion Starter • #3 • Feb 5, 2002

ya just click the mvpmotorsports.com banner up top they got what you need man

rOb~

1 - 3 of 3 Posts

Recommended Reading

2JZ-GE NA Running 14:1+ Compression

Naturally Aspirated

We are building SC300 with a 2JZ-GE NA for a Bonneville Land Speed record attempt. We're working through all the engine mods including a lot of head work. Based on the regulations we will need to run VP Racing Fuel C14. Possibly C14+ but it's unclear if that will pass tech. Does anyone have...
- 9
- 328
- N
  nick430 · updated 1 d ago
IP Hexa Pac Ignition coils

Naturally Aspirated

So I am considering doing the COP conversion and not messing with the dizzy at all during an NA-T install. I just so happened to stumble upon these and couldn't find any info or anyone that had used them in the search...
- 1
- 84
- TougeSC3 · updated 4 d ago
IS300 Coil Pack brackets for NA Supra?

Naturally Aspirated

Hi supraforum'ers, Does anyone know where I can buy some simple brackets that secure the IS300 coil packs in our non-vvti 2JZ-GE engines? I performed this coil pack conversion from a distributor cap and am planning a road trip, so I prefer them to be bolted down in a secure manner. :)
- 3
- 163
- W
  WarIsHate · updated 4 d ago
Fluidampr Crank Pulley = -2 degrees mark?

Naturally Aspirated

Hi guys (and gals?), I’m in the process of upgrading my timing belt and crank pulley. When I aligned the bolt hole notches and overlaid my new Flyuidampr crank pully over the oem 2JZ-GE (non-vvti) one, the Fluidampr’s timing mark was at -2 degrees inline with the oem crank pulley’s white...
- 4
- 144
- W
  WarIsHate · updated 6 d ago
NA-T high increasing idle after IS300 coil pack conversion AEM v1

Naturally Aspirated

Hi Supraforum'ers, Has anyone experienced a high idle 2500 rpm + (that keeps increasing) after you converted from distributor to the IS300 coil packs with AEM EMS v1 (or similar engine management system)? I set the base ignition timing with AEMPower's wizard, and made sure the throttle body...
- 2
- 141
- W
  WarIsHate · updated 8 d ago