Supra Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
313 Posts
Discussion Starter #1
Had head resurfaced and checked, couple thousand miles later had a one rod bearing wear out, all other bearings were in great shape. So was the crank and the bore honings. Of course all is being machined for the rebuild. Should the head gasket be replaced or would re-use be ok? Same question for head bolts.
 

·
JZS161 Aristo TT
Joined
·
881 Posts
onebad7m said:
:nono: NO! do not use it again! EVER! It's ok on the studs. :)
ARP can be reused gaskets are $150 on a rebuild :wtflol:

Used gasket :die:
 
1 - 5 of 5 Posts
Top