Supra Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
160 Posts
Propeller shaft = driveshaft

Remove the 4 bolts/nuts before the carrier bearing, remove the carrier bearing support bracket, and the rear section of the driveshaft should be able to fall down, then just slide the front section of the driveshaft out of the tranny. The only special tools you might need are a pair of 12mm wrenches and probably some liquid wrench/penetrating solvent.
 

· Registered
Joined
·
160 Posts
Honestly, I don't know. My supra came with most of the exhaust pieces in the back seat and hatch so I'm not entirely sure when they end up under the car. If you look at the driveshaft you will see right away what im talking about, its about 2ft away from the tranny and has a 4bolt flange connecting the 2 pieces of the driveshaft.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top