Supra Forums banner

SAFC Settings

Jump to Latest Follow

1 - 2 of 2 Posts
8

·
Registered
Joined
·
134 Posts
Discussion Starter • #1 •
I just purchased the SAFC and was looking for some input from those who have it. I have a 60-1 upgraded turbo, stock AFM and stock fuel system. Should I leave all settings at 0 until I upgrade fuel or is there some MINOR adjustments I can make to the AFC.


Thanks,

Julian
 
ZaZZn

·
Moderator, l337 M0d3r4t0r
Joined
·
12,149 Posts
#2 •
all cars are diffrent.. NO tuning should be done with out the use of a egt / a/f ratios....

Infact I don't trust any of them.. go to the wide band...

btw my car is 12:1 at 1600 F at the turbo inlet.
 
1 - 2 of 2 Posts
Recommended Reading
Read More

  1. CLEAN MKIII's... post pix here

    MKIII (1986.5-1992)
    its hard to find a true clean MKIII anymore. i'm sick of going out on weekends and all you see is a million big talkers with their little vtec/si civics, accords, integras and when you do find a supra its usually rusted up the wazoo, falling apart or destroyed cause somebody tried to rice it...

  2. Swap complete

    MKIII (1986.5-1992)
    We have finally got all the manual trans stuff installled . all I have to do now is get the clutch line sorted out. And finish up wiring.. Drain and refill trans

  3. twin disk clutch issues.... Help

    MKIII (1986.5-1992)
    Hello everyone needing some help/advice. I have been fighting this spec clutch since first install and the list of issues keeps growing. -MK3 Supra -Rebuilt R154 -Spec Twin disk clutch -Willwood master cylinder ( SPEC Super Twin Dual Disc Clutch Kit 1987-1992 Toyota Supra MK3 SS Trim ) Had to...

  5. So I picked up a 91 in decent condition...

    MKIII (1986.5-1992)
    Firstly, it's original, I'm the 3rd owner, speedo says 187k miles. Runs good, brakes good. Some power steering belt squeak. Here's what I know is wrong with it and some parts are en-route already: It’s got an oil leak or power steering leak, I can’t tell which probably both. Need to de-grease...

  6. Mk3 supra 2jzget knocking after rebuild

    MKIII (1986.5-1992)
    Ok guys I got my block back from rebuild, Cp pistons 10:1 .020 over, stock rods, standard rod bearing, stock head, arp studs. 1.5mm cometic hg. 2jzge head got new valve seals put in. I got everyting put together and it fired up. When it idles and rev up, no knocking or tapping noise, but...
Read More
About this Discussion
1 Reply
2 Participants
Last post:
ZaZZn
Supra Forums
Supra Forums is the largest online Toyota Supra MKI, MKII, MKIII, MKIV and MKV owner's club community. Discuss DIY, modifications, and upgrades.
Full Forum Listing
Explore Our Forums
MKIII (1986.5-1992) MKIV (1993-1998) Other Cars For Sale/Wanted - Parts, etc. Members Rides
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Top