Joined
·
193 Posts
what mods should be done in preparation for going bpu/at bpu? I assume smaller gapped plugs but what else? 12v fuel mod? thanks
safety mods at bpu
1 - 1 of 1 Posts
1 - 1 of 1 Posts
Join the discussion
Recommended Reading
-
VSS issue with AEM Infinity 8
MKIV TechnicalI have the AEM Infinity 8 with the plug n play harness. According to AEM the Vehicle Speed Sensor No.1 maps to pin C1-25 on the AEM ECU. I have read all about the VSS signal and the problems with it going through the Odometer. My speedometer works fine. I have depinned both the pink wire and...- 3
- 1K
-
Holset HX40 for a street a340 Aristo - Good idea?
MKIV TechnicalHey guys! It seems like my 2nd turbo is starting to go so thinking about going single. I don't know that much about turbo's yet hence I'm coming here for help. I found a nice brand new HX40 with a 60/86 billet compressor wheel and a 16cm^2 75/65 exhaust turbine. In the beginning I'd like to...- 0
- 31
-
MrSzyma · updated
-
New Wheel & Tire fitment guide.
MKIV TechnicalPlease send me an e-mail if you would like a copy of the spreadsheet. [email protected] Later, Steve- 1K
- 228K
-
Steve Jarvis · updated
-
Lukewarm Heat - WTF?!
MKIV TechnicalHello all. My name's Fred. I've been having an issue with the heat in my RHD 1993 MKIV - NA. I have searched and searched and tried everything that I've seen mentioned on here and other places as well and no improvement. The heat comes out lukewarm in all vents however blows just slightly warmer...- 3
- 134
-
Na to tt swap No Speedo working
MKIV Technicalhey guys i did a full swap my car use to be a na 5speed i swapped for a gte and a v160 now my speedo dont work. is there something i need to do i already fixed my tach by doing the mod. whats weird is when i do 70mph it reads like 5mph- 2
- 89
Join now to ask and comment!