Supra Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,826 Posts
Discussion Starter #1
What's up guys! I'm currently in the middle of doing a SC300 with a full 6SPD Supra swap for a buddy of mine. My question is, can we use the stock SC300 slave cylinder, clutch rod, etc. for the GETRAG? We have the tranny and everything else under the car bolted up minus the small tidbits I haven't yet looked at.

Vince
 

·
Registered
Joined
·
1,192 Posts
VINZE said:
...My question is, can we use the stock SC300 slave cylinder, clutch rod, etc. for the GETRAG? We have the tranny and everything else under the car bolted up minus the small tidbits I haven't yet looked at.

Vince
No. The slaves are not the same. The Getrag is a pull-style clutch; the 5-speed is push-style. The release fork, release hub, wave washers, etc. are all different. You also can't use the 5-speed hydraulic line that runs from the slave to the bell housing. You'll have to fab one; or, get it from toyota.

-scott
 
1 - 2 of 2 Posts
Top