Supra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
831 Posts
DaSupra said:
Same here. I took off my trd bar thinking that was what stopped the hood from fitting well, when it was actually the shroud. After the cuitting, then buying the new one, i havent tried to put the trd bar back on.

Ive been lazy about it to...just figuring it wouldnt work. But ima go find out for sure during my lunch break.
Please let us know if it fits! I've got a Modellista hood w a similar problem (non-TRD bar), and would like to know if I should buy a TRD strut bar instead.

Thanks! :sadance:
 

·
Registered
Joined
·
831 Posts
Thanks for the response. I think the Modellista will have the same problem as well, with the center spine and all. Maybe a little modding on the backside of the spine will give the needed clearance . Cutting away some of the spine at the contact point and laying in a flat steel or aluminum reinforcement peice in its place?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top