Size of the Intercooler?

1 - 1 of 1 Posts

Ming

Guest

Joined Jan 1, 1970

0 Posts

Discussion Starter • #1 • Sep 9, 2001

Did anyone measure the size of the "mouth" of a MKIV'?
i know Greddy's FMIC is 600x300x65mm or 23x15.5x2.5in.
but i wonder if i can put 39"x18"x3" in&outlet 3"

Input please!

1 - 1 of 1 Posts

Recommended Reading

Misfire issue, need some advice.

MKIV Technical

Note: Car was perfectly fine before it’s last wash getting it ready for a photo shoot.(engine bay was sprayed with water). So I’m driving to the photo shoot location and I start noticing a misfire. The longer I drove it progressively got worse to the point where I would just get pretty good...
- 0
- 36
- JustA2jz · updated 5 h ago
2jzgte vvti head porting, opinions please

MKIV Technical

Hi everyone, I’ve been reading supra forums for months and months now. Love this page, and this is my first post. I’m about to port my vvti head and I have some questions pertaining to the valve guides. So, assuming my guides are within spec (it’s a low mile motor), what are your professional...
- 1
- 91
- 2JZ GT86 · updated 9 h ago
Banjo bolt on fuel pump won't budge - ok to use impact wrench?

MKIV Technical

Greetings, I'm having trouble removing the banjo bolt on the fuel pump assembly. Tried everything I could think of besides an impact wrench. Wanted to ask some folks if that was a good idea or not? I'd really appreciate any insight you can offer. To be clear and avoid miscommunication I found...
- 1
- 61
- R
  RushTurbo · updated 21 h ago
shifting problems on automatic supra 2jzgte 330 hp

MKIV Technical

I have some shifting problems on this supra with a 2jzgte and a automatic box attach, as my knowledge is limited on automatic as i have worked most on manual cars, i really need som help, i have taken a video of the problems, there is no error codes stored on the ecu.. i have heard that the...
- 2
- 241
- S
  supra mkiv · updated 1 d ago
Oil Pump Install Questions

MKIV Technical

So, long story short..putting my new engine (2JZGE na-t) together and got it almost ready to put back in the car. I realized that I did not install the 2 alignment dowels for the oil pump that go in between the pump and the block. I have everything on the engine and its ready to go in back in...
- 7
- 208
- jmcboost · updated 1 d ago