Supra Forums banner

1 - 4 of 4 Posts

·
Moved to the dark side
Joined
·
989 Posts
Discussion Starter #1
Hi Guys,
Installed the ARP head studs on my engine today, but found out my socket didn't fit in the head. You really must have a very small / tiny thingy for this. The nuts are 1/2 inch for what I checked (It did fit a socket I had laying around) so anyone can point me in the right direction on whats the part number from gedore or any other brand for that socket to fit the head? I assume you need a socket on 3/8" cause my 1/2" socket is just too big.
 

·
Registered
Joined
·
2,124 Posts
I think I used a 3/8 drive deep socket from craftsman. It was tight but fit down through the head ok.
 
B

·
Guest
Joined
·
0 Posts
get another... i bought a 1/2" deepwell socket. make sure its doesnt have thick walls.

i know craftsman has them, its where i got mine :)

still looking for that t61?
 
2

·
Guest
Joined
·
0 Posts
im looking at the socket you need right now. it's a 3/8 drive 12point deepwell 13mm socket
 
1 - 4 of 4 Posts
Top