Supra Forums banner
1 - 5 of 5 Posts

· Wheel slip
Joined
·
400 Posts
Discussion Starter · #1 ·
Alright, I have welded in and ran wires from the IAT sensor that AEM suggests using when converting to their standalone unit. Now can I just snip the stock IAT sensor connector plug off and wire the AEM IAT unit accordingly to the stock 2 wire IAT harness?? I think the pinouts that AEM uses for the their IAT sensor is the same of the stock IAT unit correct?? Thanks in advance
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top