[Dukki]

Out of all the tools I've bought/borrowed, the bolts wont thread in because they were bigger. Does any know the thread size of the 2 holes on the crank pulley? I'm talking about the pulley that covers the FMS and not the crank pulley that you run the serpentine belt through. thanks

 

[Dukki]

Well, for a USDM 2jz-gte it's a 10mmx1.25 but for a jdm 2jz-gte it's a 8mmx1.00 pitch. Hope this helps others in the future.

 

[cvc9216]

you mean the timing belt gear? the holes on my jdm engine were m6x1.0. luckily I had some m6 bolts that were long enough, they needed to be ~3" for my puller