Supra Forums banner
1 - 2 of 2 Posts

· Trev
Joined
·
1,664 Posts
Discussion Starter · #1 ·
Hey Guys, I have no friggin' clue as to this Tial External wastegate hook up. Do I weld a flange to the manifold, hook it u there, then run another pipe from the outlet of the WG down to the DP? I have seen some WG that are located where the charcoal canister is....why are they way over there? how does this affect performance? Trev87supraturbo
 

· Trev
Joined
·
1,664 Posts
Discussion Starter · #3 ·
it's a 62-1, .74 a/r, p-trim----it will bolt to the stock manifold. I want it quite, so i will dump it back into the DP. what kind of wekding is required since the Ex. Man is cast iron? will the Tial flange weld to this? do I weld it as close to the cener of the Ex. man. as possible?

Trev87supraturbo
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top