Because it hits the Inake manifold
TRD Front Strut Tower Brace
I was planning on ordering a TRD Front Strut Tower Brace and the TRD Front and Rear Sway Bar Set, but all the TRD sites say that the Front Tower brace is only for the TT Supra's......
Why will it not fit on the NA's? :scratch:
http://www.trdsparks.com/displayparts.php?Mdl_dtl=229&Part_cat=11&parts_id=247
Why will it not fit on the NA's? :scratch:
http://www.trdsparks.com/displayparts.php?Mdl_dtl=229&Part_cat=11&parts_id=247
1 - 7 of 7 Posts
I've got a Supra strut tower bar on my SC300, I used spacers from aliga to clear the intake manifold.
I had a TRD strut tower and had to sell it. I added spacers to clear the intake manifold but the hood wouldnt close without hitting the strut tower. So no it wont fit.
just get something that will clear the intake mani and will fit under the hood, a lot less headache
The cusco strut clears.just get something that will clear the intake mani and will fit under the hood, a lot less headache
Well, I guess I could hold off on the Strut Tower Brace until I go NA-T with a TT style intake mani.....Because it hits the Inake manifold
1 - 7 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Supra Forums
Supra Forums is the largest online Toyota Supra MKI, MKII, MKIII, MKIV and MKV owner's club community. Discuss DIY, modifications, and upgrades.
Full Forum Listing
Explore Our Forums
