R
rwsupra.com
·Guest
Joined
·
0 Posts
I just wondering if these would fit fine on our cars withour a problem. I have a 94 MKIV NA. So if anyone can help, thanks. I think they will but I always like to ask.
Ryan
Ryan
TT Wheels
1 - 4 of 4 Posts
Joined
·
1,476 Posts
Yup!
M
money042
·Guest
Joined
·
0 Posts
fits just fine... as a matter of fact, i had a set on my car for awhile. i'm getting ready to sell my TT rims. once i get my digital camera back, you should see an ad here and/or on thePartsTrader.com. i'll probably post on SoCalSupra.com too (i prefer local pickup). i'm gonna set the price at $500-600. no tires. non-chorme. '97 model. some curb scuffs. once again, pics and official ad will be up next week or so.
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Waste-gate stuck open?
Naturally AspiratedI'm pretty sure this is a no brainier, but I had my car running up in the air on a lift after doing some repairs and inspecting. I noticed that the dump tube off of my waste-gate is puffing. Am I right to assume that the waste gate should not let anything past until it's spring pressure is...- 4
- 71
-
TrueGS300 · updated
-
IS300 Coil Pack brackets for NA Supra?
Naturally AspiratedHi supraforum'ers, Does anyone know where I can buy some simple brackets that secure the IS300 coil packs in our non-vvti 2JZ-GE engines? I performed this coil pack conversion from a distributor cap and am planning a road trip, so I prefer them to be bolted down in a secure manner. :)- 4
- 273
-
NA-T high increasing idle after IS300 coil pack conversion AEM v1
Naturally AspiratedHi Supraforum'ers, Has anyone experienced a high idle 2500 rpm + (that keeps increasing) after you converted from distributor to the IS300 coil packs with AEM EMS v1 (or similar engine management system)? I set the base ignition timing with AEMPower's wizard, and made sure the throttle body...- 7
- 332
-
Fuel pressure
Naturally AspiratedI just got my return fuel system finished up and am having an issue with setting fuel pressure. I ran a Walbro 525 pump with an 8an feed and 6 an return. FuelLab regulator on the return, with a Radium Engineering gauge. All parts high quality. I can't get the gauge to read past 20psi. The car...- 6
- 157
-
TrueGS300 · updated
-
TPS calibration
Naturally AspiratedOkay, so I have read the tsrm for the calibration method and was wondering how exactly to apply that to an aftermarket ffim with an RMR 90mm throttle body. Am I even using the right TPS sensor? I have the factory 2jzge (cali spec) TPS sensor on the car. The issue I'm having is uncontrollable...- 14
- 781
Join now to ask and comment!