Supra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter · #1 ·
I am about to hardwire my vpc and I just wanted someone to tell me I have the right idea here. All I have to do is tap the 4 wires (yellow, white, black, and red) from the vpc to the stock harness and put a 1200 ohm resistor in the mass connector right? That all I have to do according to vpc install It just seems like there are quite a few wires left in the vpc harness that are unused in this application. Just double checking. TIA
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top