[JRMSupra]

I wanna stop by the store on my way home from work and pick up some bolts to mount my 2JZ block on the stand. What size bolts do I need? Thread and lengh? I would figure it out myself, but I dont wanna make so many trips back and forth. thanks.

 

[supradupaflyguy]

i dont remember the length or thread pitch, i just found ones that worked. i would just take one of the tranny bolts up to a hardware store and they can tell you what thread they are, then just guestimate how long you will need

 

[JRMSupra]

yeah, i was trying to save a trip by just stopping on my way home.

 

[Dukki]

can't you just use the bellhousing bolts?

 

[TurboB6]

I'm using some M12 x 1.25 x 4" bolts for the engine stand.

 

[supradupaflyguy]

can't you just use the bellhousing bolts?

they wont be long enough for the engine stand

 

[hockyplyer18]

why isnt this a sticky? this question has come up a million times!

~Andrew

 

[JRMSupra]

ok, found out, they are M12-1.25, length needs to be whatever ther length of the rods on the stand plus what it takes to go into the block. in my case, they needed to be @ 3" long.

 

[Dukki]

^^
M12x1.25 is correct. I had to get 4 bolts for my motor yesterday as well.