For the low beams use #19006 PIAA [qty 2] 105wt
For the high beams use#19005 PIAA [qty 2] 110wt
For the fog lamps use #15485 PIAA [qty 2] 130wt
for the park lamps/side markers use #19169 PIAA [qty 6] 5w
All bulbs in the Super White Platinum Series,they are not HID but come close to it. They are 3800k where as the HID are 4150k
I did a basic job of replaythe Oring in the distributor car on my NA Jz. I know I have to adjust the distributor but it was start. Turns over, sounds like it’s trying but doesn’t. It was running fine until the alternator died. That has been changed with the oring
I've been trying to wrap up this 1jz (etcs-i) build but I've run into a bit of a strange problem. It's running on stock electronics and stock ecu. It'll fire up and idle at like 3,000+ rpm and will be in limp mode with the maf unplugged. However, if the maf is plugged in it'll idle...
Hi guys, I’ve recently purchased a series 2 1996 SZ and the dome light is missing. I was wondering if a dome light from a series 1 would fit or from any other Toyota vehicle e.g a celica or Corolla? Attached photo is a series 1 dome light, is it the same connection socket as the series 2?
I just installed the Driftmotion turbo kit with a Borg Warner S366 and I just tried to start the car. it starts up and sounds normal, but once the RPMs start to drop down it starts to idle rough and once i try to give it throttle to keep it going it just chokes out the car and stalls. My...