Supra Forums banner

1 - 6 of 6 Posts

·
Life begins @ 30psi....
Joined
·
2,369 Posts
Discussion Starter #1
I called AEM today to get some ECU pins so I can set my nitrous up with the AEM as the pin out I want to use are currently empty. They told me they do not sell the ECU pins anymore so now what?

Thanks,
Bob
 

·
SF.com Member #0000000023
Joined
·
1,219 Posts
Don't mess with re-using ecu pins....this can lead to a huge troubleshooting nightmare later. The ECU pins are the same as the rest of the pins on the engine harness (and probably the rest of the car for that matter). You can them new from toyota with a lead already attached very, very cheaply.

Mike
 

·
Registered
Joined
·
248 Posts
You can them new from toyota with a lead already attached very, very cheaply.
True, but what you get at the dealer will not lock in place in the Supra harness (i.e. you can grab the wire and pull it right back out) - every other US domestic Toyota harness yes, but not a Supra.
 

·
Registered
Joined
·
327 Posts
Personally, I decided not to go the ECU pin route and just purchased an Autosport 'fields' type harness. It has every wire connected into the pins, and you can just cut/solder the wires. Much easier and more dependable.

Also you can then do wiring outside the car, and just install the harness which is nice.
 
1 - 6 of 6 Posts
Top