Supra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
731 Posts
Discussion Starter · #1 · (Edited)
Wasnt sure what subforum to post this, but since its tuning related...

But does anyone know where I could get male pigtails (sensor side) for the standard GM Delphi / Packard - Metri-Pack ( Metripack ) P2S Sensor Connector used on all pressure sensors

IE: the "male" side that the connector in the pic plugs into



I need to extend some wiring for my ProEFI, and would rather use connectors than cut,solder and extend all those wires that are already in the nice heat shrink housing.

TIA!!
 

·
Registered
Joined
·
731 Posts
Discussion Starter · #3 ·
wel technically industry standard is to go by the pins...

but ya, i need the male pins or female housing.... metri-pak says on their site that not all p2s have matching connectors. i bet thats the case with these. weird...
 
1 - 2 of 2 Posts
Top