Supra Forums banner

1 - 11 of 11 Posts

·
Moderator
Joined
·
3,463 Posts
Discussion Starter #1
Just got my strut tower bar and I couldn't figure out where to put the black box that is on top of the driver side strut? Anyone know, damn thing doesn't have instructions! Thanks!
 

·
Super Moderator!!ON PATROL ALL OVER!!
Joined
·
10,459 Posts
i did the same thing!
 

·
Super Moderator!!ON PATROL ALL OVER!!
Joined
·
10,459 Posts
that how mine looks exactly also !its a very tight fit but looks neat in the end!
badmuthrfkr said:
Here is where I put mine, it's near stock looking.
 

·
Registered
Joined
·
2,236 Posts
badmuthrfkr said:
Here is where I put mine, it's near stock looking.
Did you have any fitment problems with your bar Hua? Mine doesn't fit. Got to send it back and go Cusco!!! Let me know.
 

·
BPU is so 1997
Joined
·
5,349 Posts
Supralative said:


Did you have any fitment problems with your bar Hua? Mine doesn't fit. Got to send it back and go Cusco!!! Let me know.
Actually yeah I did. Near the intake manifold, there are those black bracket type things that the bar goes over. Well it rests on top of that bracket. I took the bar off the other day, as it came with the car, and noticed that the bracket dug into the bar itself and little metal divits are made into the bar.
 
J

·
Guest
Joined
·
0 Posts
badmuthrfkr said:
Here is where I put mine, it's near stock looking.
Do you have any other pics?? I'm relocating mine as well and from the looks of your, that's where i'd like to put mine. Only problem is that I dont think I can stretch mine that far to put it up against the sidewall
 

·
Registered
Joined
·
2,236 Posts
badmuthrfkr said:

Actually yeah I did. Near the intake manifold, there are those black bracket type things that the bar goes over. Well it rests on top of that bracket. I took the bar off the other day, as it came with the car, and noticed that the bracket dug into the bar itself and little metal divits are made into the bar.
Your hood closed though I take it. I couldn't even close mine. Clearance wasn't the issue on the engine, it just didn't allow me to close the hood. IT SUCKED. Who did you buy yours through?
 

·
No Mercy
Joined
·
387 Posts
Plug it in!

I moved it to the rear half of the driver's side strut tower, there was an open bolt hold that fit perfectly with the stock bolt. Cable was a perfect length for a tight fight. Gotta love Toyota. There was also an open bracket (with nothing attached, and one small screw hole that fit the supplied bolt) where I mounted my boost sensor.

Just remember to reconnect the unit after working with the bar or else the car won't start. I've scared myself a couple times doing this since I had to remove the bar to get to the coil packs, spark plugs, etc. :)
 
1 - 11 of 11 Posts
Top