Supra Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,882 Posts
^^ Ever heard about interpunction ??

Anyway, you could do it without pulling the head and stuff. Just put it upside down. Pull the oilpan and crank and check the bearings on the rods. Why ? If a rodbearing actually spun inside the rod you have to change or repair the rod. And to change the rod you have to take the piston out. That's when the head has to come off, the pistons only go out through the top.

Still i'd rather take it all apart, rodknock contaminates the oil with metalshreds and i'd rather clean the engine top to bottom to make SURE all metal is removed. Otherwise you'll be doing this again very soon.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top