Supra Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
872 Posts
Discussion Starter · #1 · (Edited)
I just spent whole hour hauling up and down the Hwy,try to set up my profec b II
Here is my setting
set: 28
gain:40% ( does it seen right to you )?
Those setting net me 15psi and drop to 14
Can some one help me out by post you hi and lo setting?so I know where to start
TIA
Stephen

also , is it normal the reading on the profec b are 3psi lower then my autometer?
 

·
Lagger
Joined
·
216 Posts
Well i have mine.. my low is stock.. And my high is set gain .78bar, gain 25%~ set is 25%... How did you get your Gain to be at 40... Mine only goes up to 35..? My auto meter was incorrect aswell as yours(well it seems that way). I got the Greddy Elect 52mm and it does the same. So i am going to ASSUME that the amount of vaccum line will so an inaccurate reading !? Mine is fairly long. I am not sure about yours ?!
 

·
Registered
Joined
·
872 Posts
Discussion Starter · #3 ·
twinturbored90 said:
Well i have mine.. my low is stock.. And my high is set gain .78bar, gain 25%~ set is 25%...



So i am going to ASSUME that the amount of vaccum line will so an inaccurate reading !? Mine is fairly long. I am not sure about yours ?!
So, what it 's your HI boost reading?
I just" T" off the line that ran to Autometer,about the same distance.
 
1 - 3 of 3 Posts
Top