Supra Forums banner

1 - 10 of 10 Posts

·
Search
Joined
·
3,305 Posts
Discussion Starter · #1 ·
Got my emanage/e01 installed.... car starts/idles just fine but my zt2 doesn't display any more.

Before the install it worked after install it doesn't come on. I tested voltage at the zt2 box and its getting 12 volts, but the display won't come on.

ideas?
 

·
Registered
Joined
·
942 Posts
ground, or check your splitters and make sure you are getting a good connection between them. if that doesnt work, remove the spiltter and hook the display directly up to the box and see if it works.
 

·
Registered
Joined
·
942 Posts
hmm, try to get your test light grounded to the zt2 where it connects on harness, and check for power on the harness also. if that doesnt work-then dam-contact zeitronix
 

·
Search
Joined
·
3,305 Posts
Discussion Starter · #5 ·
I don't use a test light, but my fluke says its getting 12 volts :)

I guess I'll have to get ahold of them....
 

·
Registered
Joined
·
942 Posts
what is a fluke? :dunno: but if you dont have a test light, you should get one or borrow one just to make sure because zeitronix will tell you to test the connections also before sending it back.
 

·
Search
Joined
·
3,305 Posts
Discussion Starter · #8 ·
a fluke 87 is a very high quality digital multimeter


its grounded on pin e01 of the ECU
 

·
Search
Joined
·
3,305 Posts
Discussion Starter · #10 ·
so between taking off the battery terminal and putting it back on i blew the three amp SURFACE MOUNTED fuse.

who the hell surface mounts a fuse? talk about hard to solder :)
 
1 - 10 of 10 Posts
Top